We have created a awesome theme
Far far away,behind the word mountains, far from the countries

PRODUCT >MULTI-770

PRODUCT

MULTI-770

DA-770-O2

MULTI-770

Introduction
Product Overview
The oxygen analyzer is a product that can quickly and rapidly measure oxygen concentration in various places such as sintering furnaces, secondary battery research labs, process quality control, and TMS. Continuous measurement is possible using a BLDC motor.
Features
ㆍ Automatic suction: Continuous measurement possible using a micro pump
ㆍ Various signal outputs: 4-20㎃, 2 Step-Relay, RS-485 Various outputs
ㆍ Can be used in places where combustible gases are present because it uses an optical sensor
ㆍ Can measure oxygen concentration in various environments because it is not affected by miscellaneous gases
ㆍ Data LOG USB backup
Specification
Specification
Measured gas Oxygen
Measuring principle Optical
Measuring range 0.00 ~ 100%
Response time T90(within 15 seconds)
Detection method Suction Type
Input power AC 110~220 V
Suction flow rate 0.2 liter/min ~ 3 liter/min
Accuracy ≤ ±0.5% / Full Scale
Output signal 4-20㎃ DC/F.S
Display 7” TFT LED (800 X 480)
Alert display 1st alarm – AL1 LCD lamp(YELLOW)
2nd alarm – LCD lamp(RED)
Failure alarm – LCD lamp FAULT(RED)
Alarm value setting AL2/AL1 2-stage alarm-user arbitrary setting
Alarm delay time 0~99 seconds user arbitrary setting
Alarm release Manual and automatic return
Alarm output 2-stage(AL2/AL1) alarm RELAY CONTACT
Operating temperature -10℃ ~ 60℃
Operating humidity 5 ~ 95%RH (Non-Condensing)
Installation method Desktop
Gas intake Female 1/4”
Output options RS-485 communication
USB Host USB 2.0 (data log Download)
Downlaod